My experience using Device sheets has been somewhat of a pain. This method would also keep the correct mapping, but introduces some annoyances that I would rather not deal with:Įvery user would have to explicitly add the device sheet directory to their Altium preferences in order to use the component.ĭesigners would just have to know to look for the component as a device sheet instead of looking in the usual libraries. Expanding this idea to support consistency company-wide, we could instead create a device sheet out of the part. Keeping it all in a single library part guarantees that the mapping is correct for whoever uses it.Īpalopohapa mentioned that I could place the two connector parts in a subsheet with the correct mapping to expose the pins. Mapping those pins to the corresponding connector pads was a lot of work and messing up a single one of those might ruin an entire PCB run. There are 480 pins on the referenced part. Here's my reasoning: Consistent pin pad mapping I ended up keeping the system in place as I have it, and created a script to parse and correct the generated Pick and Place files.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |